Radio Front Speaker Replacement for Chevrolet Blazer - 2WD 2002

1. Remove the front speaker grille screws.
2. Remove the radio front speaker grille.
3. Remove the DRL sensor from the right speaker grille, if equipped.
4. Turn the DRL sensor counterclockwise 1/4 turn in order to remove.
5. Remove the radio front speaker screws.
6. Remove the radio front speaker.
7. Disconnect the electrical connector.

1. Connect the electrical connector.



2. Install the radio front speaker.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the radio front speaker screws.

Tighten
Tighten the radio front speaker screws to 1.9 N·m (17 lb in).

4. Install the DRL sensor to the right speaker grille, if equipped.
5. Turn the DRL sensor counterclockwise 1/4 turn in order to install.
6. Install the radio front speaker grille.
7. Install the radio front speaker grille screws.

Tighten
Tighten the radio front speaker screws to 1.9 N·m (17 lb in).

8. Inspect for proper circuit operation.