Repeater Lamp Replacement for Chevrolet Blazer - 4WD - RHD 2001

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Gently push side marker lamp toward the rear of the vehicle and pull the front end of lamp out of the fender.
3. Remove bulb assembly from side marker lamp by turning the bulb assembly.

Tape the wires to the fender in order to prevent them from dropping into the fender.

4. Remove the side marker lamp from the vehicle.

1. Remove the tape from the wires.
2. Install the bulb assembly to the side marker lamp.
3. Install the side marker lamp to the fender.
4. Connect the negative battery cable.