Transmission Support Replacement for Chevrolet Blazer - 4WD - RHD 2001

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Install the transmission jack to the transmission and support the transmission.
3. Disconnect the transmission wiring harness from the transmission support , if necessary.
4. Remove the transmission mount to the transmission support stud nuts.



5. Remove the transmission support to the frame nuts and bolts.
6. Remove the transmission support.

1. Install the transmission support.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the transmission support to the frame nuts and bolts.

Tighten
Tighten the transmission support to the frame nuts to 54 N·m (40 lb ft).




3. Install transmission mount to the transmission support stud nuts.

Tighten
Tighten the transmission mount to the transmission support stud nut to 45 N·m (33 lb ft).

4. Connect the transmission wiring harness to the transmission support , if necessary.
5. Remove the transmission jack from the transmission.
6. Lower the vehicle.