Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle for Chevrolet Cavalier 1999

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the supplemental inflatable restraints (SIR). Refer to Disabling the SIR System in SIR.
3. Remove the steering wheel. Refer to Steering Wheel Replacement
4. Remove the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .



5. Remove the 2 Torx® head screws from the multifunction switch  (2).
6. Disconnect the electrical connectors from the multifunction switch (2).
7. Remove the multifunction switch (2) from the steering column.

1. Install the multifunction switch (2) to the steering column.
2. Connect the electrical connectors to the multifunction switch (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the 2 Torx® head screws to the multifunction switch (2).

Tighten
Tighten the screws to 6 N·m (53 lb in).

4. Install the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .
5. Install the steering wheel. Refer to Steering Wheel Replacement .
6. Enable the SIR system. Refer to Enabling the SIR System in SIR
7. Connect the negative battery cable.
8. Ensure that the multifunction switch functions properly.