Tail/Turn Signal Lamp Replacement for Chevrolet Corvette 1998

Tail/Turn Signal Lamp Replacement Europe, Japan

1. Remove the screws retaining the tail/turn signal lamp assembly to the rear fascia.
2. Remove the lamp from the fascia to gain access to the tail and turn signal lamp sockets.
3. Remove the sockets from the lamp assembly.
4. Remove the bulbs from the sockets, if replacing the bulbs.
5. Remove the lamp from the vehicle.

1. Install the bulbs to the lamp sockets, if replacing the bulbs.
2. Install the sockets to the lamp assembly.
3. Position the tail/turn signal lamp assembly to the rear fascia.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the tail/turn signal lamp screws to the rear fascia.

Tighten
Tighten the tail/turn signal lamp screws to 2 N·m (18 lb in).