GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Corvette 🢒 Restraints 🢒 SIR 🢒 Steering Wheel Replacement

Steering Wheel Replacement for Chevrolet Corvette 2005

Tools Required

    • J 36541-A Steering Wheel Puller Legs
    • J 1859-A Steering Wheel Puller
    • J 42640 Steering Column Lock Pin

Removal Procedure

    Object Number: 70114 Size: SH
  1. Remove the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  2. Remove the horn electrical connector.
  3. Install J 42640 to the steering column.
  4. Remove the steering wheel set nut.
  5. Discard the steering wheel set nut.
  6. Install J 36541-A and J 1859-A to the steering wheel.
  7. Tighten the puller center screw against steering column shaft until the steering wheel slides off the steering column shaft.
  8. Remove J 36541-A from the steering wheel.

Installation Procedure

    Object Number: 309617 Size: SH
  1. Install the steering wheel to the steering column, observing the alignment marks.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install a new steering wheel set nut.

    3. Tighten
    Tighten the nut to 41 N·m (30 lb ft).

  3. Remove J 42640 from the steering column.
  4. Connect the horn electrical connector.
  5. Install the steering wheel inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.