Rear Object Alarm Module Replacement for Chevrolet Uplander 2009

1. Remove the right rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
2. Disconnect the electrical connector from the rear object detection module.
3. Remove the mounting bolts from the rear object detection module.
4. Remove the rear object detection module from the vehicle.

1. Align the rear object detection module to the vehicle.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the rear object detection module mounting bolts and tighten to 10 N·m (89 lb in) .
3. Install the electrical connector to the rear object detection module and press in the locking tab.
4. Install the rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
5. Refer to Control Module References for programming and setup information.