Driver Information Center Replacement for Chevrolet Venture - 4WD 2002

1. Remove the overhead console. Refer to Roof Console Replacement in Interior Trim.



2. Remove the driver information display to overhead console screws.
3. Remove the driver information display from the overhead console.

1. Install the driver information display to overhead console.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the driver information display to overhead console screws.

Tighten
Tighten the screws to 1 N·m (9 lb in).

3. Install the overhead console. Refer to Roof Console Replacement in Interior Trim.
4. Set the compass magnetic variation. Refer to Driver Information Center (DIC) Description and Operation .
5. Calibrate the compass. Refer to Driver Information Center (DIC) Description and Operation .