For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC C0558 00: Calibration Data Not ProgrammedDiagnostic Fault Information
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Circuit/System Description
The electronic brake control module (EBCM) must be calibrated/programmed or has an internal fault and requires replacement.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | Ignition voltage is between 9 and 16 volts. |
Conditions for Setting the DTC
The EBCM has not been calibrated or has an internal fault.
Action Taken When the DTC Sets
| • | The EBCM disables the ABS and the TCS for the duration of the ignition cycle |
| • | The ABS fault indicator on the driver information centre (DIC) is activated. |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
| • | The DTC can be cleared using a scan tool. |
Reference Information
Schematic Reference
Antilock Brake System Schematics .
Connector End View Reference
Component Connector End Views .
Electrical Information Reference
| • | Circuit Testing . |
| • | Wiring Repairs . |
Scan Tool Reference
Circuit/System Testing
- Verify that no other DTCs are not set.
- Calibrate/programme the EBCM.
- Ignition ON, using the scan tool view the current DTCs.
| ⇒ | If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle . |
| ⇒ | If DTC C0558 is set to current replace EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup and programming
