High Mount Stop Lamp Replacement for HUMMER H2 2003

High Mount Stop Lamp Replacement SUV

1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement in Body Rear End.



2. Disconnect the electrical connector from the high mounted stop lamp.
3. Remove the retaining screws.
4. Remove the grommet from the liftgate.
5. Remove the lamp, with the attached harness, from the vehicle.

1. Install the lamp, with the attached harness, to the vehicle.



2. Install the grommet to the liftgate.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the retaining screws.

Tighten
Tighten the screws to 3 N·m (26 lb in).

4. Connect the electrical connector to the high mounted stop lamp.
5. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement in Body Rear End.