Power Brake Booster Inlet Hose Replacement for HUMMER H2 2008

Tools Required

CH-47830 Holding Fixture

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

1. Using a suitable tool, remove the brake fluid from the master cylinder reservoir.

Discard the brake fluid into an approved container.

2. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement .
3. Install the CH-47830  (1)  to the master cylinder assembly.
4. Position the CH-47830 with the master cylinder assembly in a vise.



5. Remove the power brake booster inlet hose roll pin (1).
6. Release the hose clamp at the master cylinder reservoir and remove the inlet hose (2) with the union from the power brake booster and the master cylinder reservoir.
7. Remove the inlet hose union O-ring seal (3).

1. Install the inlet hose union O-ring seal (3).
2. Release the hose clamp at the master cylinder reservoir and install the inlet hose (2) with the union to the power brake booster and the master cylinder reservoir.
3. Install the power brake booster inlet hose roll pin (1).



4. Remove the CH-47830  (1) from the master cylinder assembly.
5. Install the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement .