Vehicle Speed Sensor for Oldsmobile Bravada 2001

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Disconnect the electrical connector from the vehicle speed sensor.



3. Remove the following parts:

•	The vehicle speed sensor

•	The O-ring seal

1. Coat a new O-ring seal with a thin film of transmission oil.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the following parts:

2.1.	The O-ring on the vehicle speed sensor assembly.

2.2.	The vehicle speed sensor assembly.

Tighten
Tighten the bolt to 16 N·m (12 lb ft).




3. Install the electrical connector to the vehicle speed sensor.
4. Lower the vehicle.