Driver or Passenger Seat Shoulder Belt Guide Adjuster Replacement for Oldsmobile Intrigue 2000

1. Open the seat belt guide loop cover.
2. Remove the guide loop nut.
3. Remove the guide loop from the guide adjuster bracket.
4. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement in Interior Trim.



5. Remove the shoulder belt guide adjuster bracket bolts.
6. Remove the shoulder belt guide adjuster bracket from the center pillar.

Important: Verify that the release lever at the top of the bracket is in the full up position.




1. Position the shoulder belt guide adjuster bracket to the center pillar.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the shoulder belt guide adjuster bracket bolts.

Tighten
Tighten the bolts to 42 N·m (31 lb ft).




3. Install the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement in Interior Trim.
4. Install the guide loop to the guide adjuster bracket.
5. Install the guide loop nut.

Tighten
Tighten the nut to 42 N·m (31 lb ft).

6. Close the seat belt guide loop cover.