GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Grand Prix 🢒 Body and Accessories 🢒 Entertainment 🢒 Steering Wheel Controls Inoperative

Step

Action

Value(s)

Yes

No

1

Did you review the symptom list?

--

Go to Step 2

Go to Symptoms

2
  1. Using a test lamp, backprobe between connector C205 terminal A to ground.
  2. Turn the ignition switch on.

Is the test lamp light?

--

Go to Step 4

Go to Step 3

3

Repair the poor connection or the open in circuit 43.

Is the repair complete?

--

Go to Step 15

--

4
  1. Disconnect connector C205.
  2. Connect a DMM between C205 (female side) terminal A and terminal C.
  3. Press each of the left steering wheel control buttons one at a time.

Are the resistances approximately equal to the specified values?
    • Volume Up: 294ohms
    • Volume Down: 348ohms
    • Source: 475
    • Mute: 715
    • Seek Up: 1180ohms
    • Seek Down: 2370
    • Scan: 6980ohms

Go to Step 8

Go to Step 5

5
  1. Disconnect the left radio control switch.
  2. Connect a DMM between the left radio control switch pigtail harness connector terminal A and terminal C.
  3. Press each of the left steering wheel control buttons, one at a time.

Are the resistances approximately equal to the specified values?
    • Volume Up: 294ohms
    • Volume Down: 348ohms
    • Source: 475
    • Mute: 715
    • Seek Up: 1180ohms
    • Seek Down: 2370
    • Scan: 6980ohms

Go to Step 7

Go to Step 6

6

Replace the left radio control switch. Refer to Steering Wheel Control Switch Assembly Replacement .

Is the repair complete?

--

Go to Step 15

--

7

Replace the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.

Is the repair complete?

--

Go to Step 15

--

8
  1. Using a test lamp, backprobe between the radio harness connector terminal E6 to ground.
  2. Turn the ignition switch ON.

Is the test lamp light?

--

Go to Step 9

Go to Step 10

9

Repair short to B+ on circuit 1796.

Is the repair complete?

--

Go to Step 15

--

10

Using a DMM, measure the resistance between the radio harness connector terminal E6 and ground.

Is the resistance measured equal to the specified value?

∞

Go to Step 12

Go to Step 11

11

Repair short to ground in circuit 1796.

Is the repair complete?

--

Go to Step 15

--

12

Test for a poor connection or an open in circuit 1796.

Did you find a poor connection or an open in circuit 1796?

--

Go to Step 13

Go to Step 14

13

Repair the poor connection or the open in circuit 1796.

Is the repair complete?

--

Go to Step 15

--

14

Service the radio. Refer to Radio Replacement .

Is the repair complete?

--

Go to Step 15

--

15

Operate the system in order to verify the repair.

Did you correct the condition?

--

Go to Symptoms

--