Control Valve Body Cover Replacement for Pontiac Torrent 2006

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the left splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
4. Remove the front engine mount. Refer to Engine Front Mount Replacement in Engine Mechanical - 3.4L.
5. Remove the transaxle oil cooler lines and seals from the transaxle. Refer to Fluid Cooler Pipe Seal Replacement



6. Remove the 9  TORX bolts (2) from the control valve body cover (1).

Important: Do not pry with a tool on the transaxle control valve body cover, case or sealing surfaces.

7. Remove control valve body cover.

1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
2. Install a 3 mm (0.125 in) bead of RTV sealer GM P/N 89020326 (Canadian P/N 89021188) onto the control valve body cover.



3. Install the control valve body cover (1) onto the transaxle case.

Important: Use LOCTITE™ 242 thread sealer on ALL bolt threads.

4. Install the control valve body cover bolts (2) hand tight.

Notice: Refer to Fastener Notice in the Preface section.




5. Tighten the control valve body cover bolts in the sequence shown.

Tighten
Tighten the bolts to 13 N·m (115 lb in).

6. Install the transaxle oil cooler lines and seals to the transaxle. Refer to Fluid Cooler Pipe Seal Replacement .
7. Install the front engine mount. Refer to Engine Front Mount Replacement in Engine Mechanical - 3.4L.
8. Install the left splash shield. Refer to Engine Splash Shield Replacement in Body Front End.
9. Install the left front wheel and the tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
10. Lower the vehicle.
11. Check the transaxle fluid level. Refer to Transmission Fluid Check .