Crankshaft Position Sensor Replacement for Saab 9-7x 2005

Important: Perform Crankshaft Position System Variation Learn whenever the crankshaft position (CKP) sensor is removed or replaced.

1. Remove the starter. Refer to Starter Motor Replacement .
2. Disconnect the electrical connector (2) from the CKP sensor (1).



3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.

1. Install the CKP sensor.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the CKP sensor bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




3. Connect the electrical connector (2) to the CKP sensor (1).
4. Install the starter. Refer to Starter Motor Replacement .