Low/Reverse Servo Assembly Replacement for Saturn VUE - FWD 2006

1. Remove the oil feed pipes. Refer to Oil Feed Pipes Replacement .



2. Remove the 3 low and reverse band servo cover bolts, the servo and the spring.
3. Disassemble, clean and inspect the low and reverse servo assembly. Refer to Low and Reverse Servo Disassemble .

1. Assemble the low and reverse servo. Refer to Low and Reverse Servo Assemble and Installation .

Notice: Refer to Fastener Notice in the Preface section.




2. Install the lo and the reverse band servo cover bolts.

Tighten
Tighten the bolts to 12 N·m (106 lb in).

3. Install the oil feed pipe. Refer to Oil Feed Pipes Replacement .

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
4. Reset the TAP values. Refer to Transmission Adaptive Functions .